Topics created by mfoltz

They are truly always on.

You are using fan 0 for thermostatic control, however fan 0 is the default print cooling fan. There is probably a command in the gcode file you are trying to print that turns it off. We recommend you keep fan 0 as the print cooling fan and use fan 1 output to control the heatsink fan.

It's M307 you need not M305.

Yes that should be OK.

Why do you want to change the sensitivity? Do you get errors during the print that stem from it?

and the wiki describes a blinking pattern of the LED that confirm if your are on the default or if it accepted your custom value.

Personally, i also though i needed to change the sensitivity but after 2-3 test I went back to default and havent had an issues since.

Cheers

0 Step errors, changed to the settings recommended now the lowest deviation I can get is .039 instead of .033 but the twisting is almost gone. It is still there but barely and nowhere near as much as it was.