@droftarts

Thanks for the file.
I have made a Dutch translation.
1644677487089-dutch-translation-.txt

Feel free to ask if the text is to long.

@droftarts

Thanks for the file.
I have made a Dutch translation.
1644677487089-dutch-translation-.txt

Feel free to ask if the text is to long.

I like to see the Dutch translation.
If i need to help................ i am Dutch.

@phaedrux

start.g homez.g homeall.g config.g bed.g

The sliced gcodes file.
Caribou Short_Key_Tray_0-holes-3_hooks-lip.gcode

Firmware version :
Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.4.0 (2022-03-15)
Duet WiFi Server Version: 1.26

@dc42 The hot-end and bed are heating up before homing. (160-60)
The second step is making the height map.
Then the printer is homing and is waiting for the hot-end to heat up (215).
The build plate is already on the good temp. Is the Pinda 2 the source of the troubles ?
I think it is a software problem........ If i wait between the first and second print, the hot end and bed are cold.

I have a Caribou Duet and i have problems with the first layer.
If i turn on the printer and start printing, the first layer is to high from the bed.
The print is canceld and i start the print again.
The second print is the first layer spot on.......perfect first layer. Al the prints that day perfect.

I have don several times a first layer calibration and saved the babysteps but the problem is still here.

First print to high...... second print spot on.

Thanks for this update.
I can see the thumbnails on the pc using webcontrol.
But i see no thumbnails on the PanelDue.
On the PanelDeu is the latest firmware 3.4.1-pre2.
The slicer i have is Prusaslicer and thumbnails are 160x160.