Topics created by MiracuruZRH

Fortunately I was so foreseeing that I kept the modified sources. I made a new build based on the (to be released) 2.04RC2 version including M574 Cnnn parameter.

Note that I consider this an intermediate solution until you are able to upgrade to RRF 3.

I uploaded the firmware binary to my Dropbox.

You might be able to open the Console on the PanelDue and enter M292 manually to avoid going back and forth between rooms (or add a "continue" macro with just M292 for more convenience) until David had time to investigate.

@miracuruzrh said in Y Axis Zero at wrong end:

Therefore I'm confused. What exactly is the S parameter?
Is it the the position at which side the endstop is positioned. At the low or at the high side of the Axis?

The S parameter defines the switch type, as in Normally Open, Normally Closed, etc.

The position of the endstop is defined by the number after the Axis letter. So X1 means the X endstop is at the low end of travel. Y2 means the Y axis endstop is at the high end of travel.