Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. moe.adams9093
    3. Best
    • Profile
    • Following 0
    • Followers 0
    • Topics 16
    • Posts 148
    • Best 8
    • Controversial 0
    • Groups 0

    Best posts made by moe.adams9093

    • RE: G29S1 not loading during print and G32 not leveling properly

      @Phaedrux I'm going to drive on top of it and see if that will make it flat

      posted in IR Height Sensor
      moe.adams9093undefined
      moe.adams9093
    • RE: Auto bed leveling

      Yes I forgot my build with corxy.

      posted in Duet Hardware and wiring
      moe.adams9093undefined
      moe.adams9093
    • RE: CNC Setup Duet 3D 6XD Controller Board

      @fcwilt Thank you, for all your help.

      I did figure it out I was using the old configurator tool for the 3.5 firmware, and I didn't know that Reprap has a new configurator tool after I did a new config setup the motors are working fine now these are just testing motors next step is going with the 1 HCL + Moons Nema 24 with the incremental encoder so hopefully that goes smooth.

      posted in CNC
      moe.adams9093undefined
      moe.adams9093
    • Multiple Z probes and multiple Z axis for IDEX

      Hello I have a question regarding Z probes for bed mesh compensation. I’m building new printer with dual extrusion IDEX can I have 2 Z probes installed one for each extruder and both extruders can compensate at the same time while printing. My Bed is controlled with 4 Z axis motors. Thank you

      posted in Firmware wishlist
      moe.adams9093undefined
      moe.adams9093
    • RE: G32 ERROR

      Ok make sense thank you

      posted in Duet Hardware and wiring
      moe.adams9093undefined
      moe.adams9093
    • RE: G32 ERROR

      Yeah I'm going to try 3.3 and do duex.e2stop all the way to duex.e6stop and see how its going to behave

      posted in Duet Hardware and wiring
      moe.adams9093undefined
      moe.adams9093
    • RE: G32 ERROR

      I just found a solution to this problem. and it's a very simple fix. All I have to do is swap Driver 9 and Duex.e6stop to Z Drive and !Zstop that will put my string under 50 Char. But first I need to go back to 3.1.1 because 3.3 is acting a little weird.

      posted in Duet Hardware and wiring
      moe.adams9093undefined
      moe.adams9093
    • RE: G32 ERROR

      Never mind I figured it out

      posted in Duet Hardware and wiring
      moe.adams9093undefined
      moe.adams9093