@o_lampe Thank you. This solved my problem.
Kind Regards
Poul Erik
Latest posts made by Poul Erik
-
RE: Deltaprinter "probe already triggered at start of probing move"
-
RE: Deltaprinter "probe already triggered at start of probing move"
@Phaedrux Thank yo for your reply.
I increased the "H" parameter in the Z-probe definition, as suggested by @o_lampe. This solved my problem.
Thank you again.
Kind Regards
Poul Erik -
Deltaprinter "probe already triggered at start of probing move"
Hi forum
I could need help diagnosing a problem with probing.
I am running Duetwifi and the IR probe.
The printer has been running without problems till now, but recently a problem accured.
The probe is working on the first couple of probing positions, but as it moves to a new position it skips the probing and continues to the next position. There is a error message when a probing point is skipped "probe already triggered at start of probing move".
Any help would be greatly appreciated.
Kind Regards
Poul Erik -
RE: 230v heatbed thermal runaway
Thank you @achrn
Your time is much appreciated.
I will change the SSR and see if this solves my issue.
//pe -
RE: 230v heatbed thermal runaway
@zapta said in 230v heatbed thermal runaway:
Duet and the SSR, does the bed heats when you turn the printer on? If so, you may have shorted SSR.
Also, does your SSR have a led, indicating the control signal? I so, it will help you identify if the problem is on the duet/firmware side or the SSR.Thank you @zapta
What might cause the SSR to short?//pe
-
RE: 230v heatbed thermal runaway
@gixxerfast said in 230v heatbed thermal runaway:
the input of the SSR, does the LED on the SSR (if there's one) light up ?
HI @gixxerfast The heatbed will turn on even if the bed is not marked as active.
There is no led on the SSR.Thank you.
Poul Erik -
RE: 230v heatbed thermal runaway
@t3p3tony
Thank you Tony, I really appreciate your time.
The wiring is pretty standard and worked until yesterday.
I suspect you are asking for somthing other than what the image is showing! But what?
Kind Regards
Poul Erik -
RE: 230v heatbed thermal runaway
@t3p3tony
i would have to take the printer apart to answer how the it is wired. -
RE: 230v heatbed thermal runaway
@t3p3tony
Yes, it starts heating rightaway.