Hello,
I am building a large printer that will use 6 ac heaters on SSRs and realized there are only 4 Thermistor spots.
Would I need to use the Temp daughter board and PT100s for the last 2?
I'm using Ou0-3 and Ou7-8 for the bed heaters. Using two toolboards for the hot ends and two duet3 1XDs for the Clear path servos.
To my understanding, the temp pins on the 1XDs can't be used to control a heater output?
@droftarts Hey thanks a bunch I'll swap it over when I get home and be WAY more careful with this one.
@dc42 Damn. Can I use the E1 driver for the y-axis then?
Nope. Turned of power before pulling wires.
So I was having trouble with y-axis losing steps here and there so I upped the current to 900mA. Worked for a while but I decided to replace the motor with a slightly larger nema 17 that I had laying around. The new motor just vibrated so I figured I had the wires in the wrong order(they were). Fixed them and it still did the same thing and there was a grounding error on screen. Next I put a motor I know was good on the y driver. Smoke. Panic. Kill power.
Now what do I do?