@phaedrux Will try to get the wiring photos this weekend. This was only ever connected to the mini 5+. It was initially just hooked up outside the box and then was placed into the printer controller box and wired up.

@Phaedrux I have uploaded the 3.4 firmware to the PanelDue and upgraded to 3.41 on the Duet. The PanelDue was running 1.25 and the Duet had 3.40 so all the firmware should now be current release.

@dc42 I connected to the USB on the Duet, I tried connecting via 9600 baud and 57600 baud. I don't see any responses to screen. I tried sending homing commands and manually typed in a G1 X10 command using the console on the PanelDue. No response.

I don't see anything that could be shorting out anywhere. All the crimps appear solid. Not seeing any loose wiring. Anything else I can check?

@phaedrux I will try to double check later this weekend. Unfortunately I have quite a few late workdays coming up.

Not sure if my PanelDue is broken. It used to work before I moved the Duet 5 mini into a new machine, but now it just says "connecting".

I didn't move the port it was connected to, IO_0, and I have the "M575 P1 B57600 S1" line in my config.g file. I've gone and tested the same cable I was using before with a multimeter with no issues. I also confirmed it's using the 57600 Baud rate in the settings on the PanelDue itself.

I have not updated any firmware since I moved it on either the Duet 5 mini, or the paneldue.

Is there anything else I can check on this?