Topics created by supertb1

@supertb1 @Phaedrux, please go ahead and mark this issuer as solved. Thanks for every one help.

@supertb1 thanks, I'll mark it as solved then.

@T3P3Tony HI Tony, installed the new board, uploaded the latest firmware and all is well, This issue is closed on my end. Thanks so much for your assistance to all @elmoret @droftarts @Phaedrux @dc42

@dc42 said in 1HCL 1.0 closed loop controller:

@supertb1 the homing move or moves should aways be done in open loop mode, and should be followed by the basic tuning move before switching to closed loop.

You mean after homing, switch to closed loop and THEN do the tuning maneuvre? The documentation states it that way...?
Still having trouble with my Nema34's closed loop so i'm looking at everything right now.

@dc42 OH MY GOD... the chip set on the new 1HCL boards are so much more efficient than the drivers on the Duet 3 6HCL boards.... I love it... you guys are awesome!!!!!

many thanks... I'll get it ordered today... I'll leave you guys be for a while... headed to Cancun after christmas so it will be after that before I can get to this project... have a great holiday

it is about 3 meters of wire from one end to the other and the harness has 16 conductors in it to run several fans, temp sensor, heater wires, extruder motor and the BLtouch. I use those speed butt connectors for my wire ends as it makes terminations very easy. once I get all the terminations finalized I will stream line it and work on cable management.