and my Stall detection did not react anymore since update. No Change between -60 and +60

7.2.2020, 15:44:15 G32
Leadscrew adjustments made: -0.141 -0.114 -0.166, points used 3, deviation before 0.133 after 0.000
7.2.2020, 15:43:27 G32
Leadscrew adjustments made: -0.138 -0.151 -0.140, points used 3, deviation before 0.144 after 0.000
7.2.2020, 15:41:24 G32
Leadscrew adjustments made: -0.069 -0.167 -0.206, points used 3, deviation before 0.141 after 0.000
7.2.2020, 15:40:40 G32
Leadscrew adjustments made: -0.133 -0.130 -0.066, points used 3, deviation before 0.122 after 0.000
7.2.2020, 15:39:26 G32
Leadscrew adjustments made: -0.349 0.038 -0.080, points used 3, deviation before 0.176 after 0.000
7.2.2020, 15:38:36 G32
Leadscrew adjustments made: -1.094 0.434 -0.084, points used 3, deviation before 0.524 after 0.000
7.2.2020, 15:37:52 G32
Leadscrew adjustments made: -2.909 2.198 -0.556, points used 3, deviation before 1.563 after 0.000

still the same problem.. made me so mad. there must be 1 fault anywhere.

bed.g homeall.g config.g

(Next Problem my Fan is now always on and they did not get shown on Web Control after update)

Thanks for help

@Veti @droftarts

Yes that is exactly how it looks like.

@droftarts

Thats it. I forgot a jumper to set on the board. I will uploadt a picture later for anybody who had the same problem.

thanks

@dc42

Yes thats the problem. got only 1Volt on the Powersupply and 3.3v on usb

fixed it with wiring on.

But now my Modul still not running without Usb.

https://forum.duet3d.com/topic/14247/wifi-module-not-starting-on-boot/6

@dc42

help

Im powering with a 24V Power supply. using the internal 5v than

looks like the Modul is not powered without usb connection. i popt out the usb and the modul shut down.

@dc42 said in WiFi module not starting on boot:

G4 P1000

Y added M552 S1 at start-

checked for the rest with strg-f.
everything is clear.