Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Thats it. I forgot a jumper to set on the board. I will uploadt a picture later for anybody who had the same problem.
thanks
@dc42
@chrishamm Thank you 🙂
@Tobs94 For M915 stall detection, you've copied the two examples from https://duet3d.dozuki.com/Wiki/Gcode#Section_M915_Configure_motor_stall_detection ... twice! It will be using the last M915 command, M915 X Y S2 F1 R0. For more detail on setting up stall detection, see https://duet3d.dozuki.com/Wiki/Stall_detection_and_sensorless_homing
Ian
