Topics created by travasky

@trulm said in Scanning Z Probe giving erratic Z values:

but when I start the G29 or G32, all points of the mesh are on 0.0mm deviation.

Can you explain more what you mean by this?

@OwenD
That worked. Funnily enough, I swear I tried that exact same format once before. In any case, thank you for the time to make the suggestion. All in all I think that solves the functionality issue, but still the formatting error is something @dc42 can look into in case its affecting others as well.

one for @chrishamm

@travasky said in Chamber circulation fan control:

@mrehorstdmd how are you getting around the fans turning off / pulsing when the chamber hits the target temp? In the original machine fans were on 100% of the time the machine was on. In my case I'd like the ability to control them if I decide to print a material other than ABS for example. I added a heated bed to give me flexibility on materials instead of the plastic build plate that was passively heated on the original. Seems like a shame to not be able to use or not use the fans at will.

I don't. The fan turns on and off with the heater. The printer is tall and the heater/fan located at the bottom of the machine. I only heat to 50C when printing ABS and don't want a lot of air movement at the print, so for my printer, it's fine that the fan is low powered and doesn't spin continuously.

@chrishamm Thank you!