Topics created by VULCAN

Two choices;

4-wire connection (best): connect pins T1, T2, T3 and T4 to one of the 4-way terminal blocks on the PT100 daughter board in the same order (it doesn't matter which end you start from). Remove the jumpers from the two pairs of jumper pins on that channel of the daughter board.

2-wire connection: connect T2 and T3 to the middle 2 pins of the 4-way terminal block on the PT100 daughter board. Fit jumpers on both pairs of jumper pins on that daughter board channel.

See the wiki for how to configure PT100 sensors in firmware.

Still can't get this ideamaker to work, shame as it looked very interesting. Will have to stick with slicer for now.

Hi Rob,

I'm glad I could help.
It does take some learning curve the learn how to handle the Duet.
fortunately, the DuetWiki is very informative, and I would recommend you to invest some time in reading the wiki.
Also, the support in the forum is superb, so I am sure you will be able to make your machine print excellent models very soon.