Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Walternate
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 3
    • Posts 15
    • Best 1
    • Controversial 0
    • Groups 0

    Topics created by Walternate

    • Walternateundefined

      Stepper motor wire causing interference

      Duet Hardware and wiring
      • • • Walternate
      13
      0
      Votes
      13
      Posts
      1.0k
      Views

      Vetiundefined

      @lorenzop said in Stepper motor wire causing interference:

      I found the limit switch is bouncing erratically when the stepper turns on.

      see this marlin page about hardware solutions for that.
      https://marlinfw.org/docs/hardware/endstops.html

    • Walternateundefined

      Making babysteps permanent in gcode

      Tuning and tweaking
      • • • Walternate
      13
      0
      Votes
      13
      Posts
      1.1k
      Views

      Phaedruxundefined

      @zapta your z and e settings are pretty conservative too. For z it only needs to be as fast as needed to keep it from causing problems with mesh compensation or delays at layer change causing blobs.

      For E it would be a matter of tuning along with retraction and pressure advance. The extruder isn't moving a lot of mass around so it can be very quick without problems. My values are an order of magnitude higher than yours for direct drive for instance. 3000-4000 should be enough to let pressure advance do its thing without slipping or skipping. Does not apply to remote direct drive or very high gear ratio drives.

    • Walternateundefined

      Duet 2 Maestro Ender 5 Plus print speeds won't go above 12mm

      Tuning and tweaking
      • • • Walternate
      19
      0
      Votes
      19
      Posts
      692
      Views

      droftartsundefined

      @Damien Please start a new thread for your issue. It's not the same as this thread. Consult the guide for posting here https://forum.duet3d.com/topic/5909/guide-for-posting-requests-for-help and provide the information needed for others to help you.

      Ian