Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
If you're using a probe, you must redo this calibration.
https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe#Section_Calibrate_the_Z_probe_trigger_height
If you're using an endstop, you may need to change your homeall if you use G92 Z to set the z height.
?
@wickedracer said in Duet WiFi connects to my IP but no DWC.:
site not found
which browser? sounds like a dns issue, but if you're tying in the IP then that doesn't make sense.
in any case verify the index.htm.gz file is in /www on the sd card with M20 P/www either on the PanelDue console or usb serial console.
@wickedracer said in WiFi IP is found on the Duet but will not open the DWC:
Type: Guest
I'd guess the router is not allowing other devices to connect to the Duet because it is connected as a guest. You probably need to register the MAC address of the Duet in the router.
Ian
