Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Wild Bill Diamond
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 5
    • Posts 36
    • Best 5
    • Controversial 0
    • Groups 0

    Topics created by Wild Bill Diamond

    • Wild Bill Diamondundefined

      Duetwifi board seems bad

      General Discussion
      • • • Wild Bill Diamond
      22
      1
      Votes
      22
      Posts
      552
      Views

      dc42undefined

      @wild-bill-diamond I suspect the problem may be a bad solder joint rather than a hairline crack (assuming that you can't see a crack) and may therefore be recoverable. I suggest you start by examining visually using magnification the solder joints of the driver 3 TMC2660 chip and the surrounding components.

      It may also be helpful to see a full M122 response that includes the driver 3 status.

    • Wild Bill Diamondundefined

      Homes fine but Y axis acts crazy when trying to move manual

      Duet Hardware and wiring
      • • • Wild Bill Diamond
      2
      0
      Votes
      2
      Posts
      296
      Views

      Scachiundefined

      @wild-bill-diamond
      That sounds like wrong polarity or a bad crimped contact / wire.
      Check the wires/contacts/connections to your Y stepper with a multimeter

    • Wild Bill Diamondundefined

      Hotend faults

      General Discussion
      • • • Wild Bill Diamond
      9
      0
      Votes
      9
      Posts
      802
      Views

      Wild Bill Diamondundefined

      Ok fixed the problem set M570 for S180 now it works

    • Wild Bill Diamondundefined

      Driver install for USB

      General Discussion
      • • • Wild Bill Diamond
      28
      0
      Votes
      28
      Posts
      4.5k
      Views

      Wild Bill Diamondundefined

      M587 or M587p remembered networks TNCAP2FCC19 or M587S bad paramter in M587S

    • Wild Bill Diamondundefined

      Goofed up my duetwifi

      General Discussion
      • • • Wild Bill Diamond
      5
      0
      Votes
      5
      Posts
      544
      Views

      dc42undefined

      Check that you have downloaded the file correctly, it should be a little over 300kb in size. In Bossa check boxes Erase all, Lock and Boot from Flash before pressing Write. After writing the firmware, press Reset or power the board off then on, and the Duet port should appear in p!ace of the Bossa port.