BondTech CR-10S Extrusion Problem

Veti

@Kaizer said in BondTech CR-10S Extrusion Problem:

M305 P0 T100000 B4138 R4700 ; set thermistor + ADC parameters for heater 0
M305 P1 T100000 B4138 R4700 ; set thermistor + ADC parameters for heater 1

also you are most likely printing at the wrong temperature. B4138 is the default and most likely wrong for your thermistors.

Kaizer

@deckingman Thanks. It makes a lot of sense now.
My Slicer start Gcode is only
G28 ; home all axes
G1 Z5 F5000 ; lift nozzle

should i add T0 as u said? if yes can u give me an example of the completed code?

Kaizer

@Veti i see, Im actually wondering about it too. but since i dont know much about it. i just leave it as is and do a temperature tower later on.

Im using the stock Bed thermistor for CR-10S and E3D V6 Tube Thermistor for my hotend. i dont know what their names are so idk what to set my thermistor as. if you know, mind sharing it? thanks.

deckingman

@Kaizer Literally, it's just "TO" on a new line (without the quotes). So:

G28 ; home all axes
G1 Z5 F5000 ; lift nozzle
T0

or put the T0 first if you need to heat the hot end before homing.

Kaizer

@deckingman Thanks alot. will give it a try now.

Veti

@Kaizer said in BondTech CR-10S Extrusion Problem:

E3D V6

if its a genuine E3D the settings are: B4725 C7.060000e-8

Kaizer

@Veti Thanks, so its gonna be

M305 P1 T100000 B4725 C7.060000e-8 ; set thermistor + ADC parameters for heater 1

?

Veti

correct. the r parameter is not required as will be replaced by the correct one for your board.

Kaizer

@Veti what do u mean by r parameter? sorry i dont really understand programming language.

Veti

@Kaizer said in BondTech CR-10S Extrusion Problem:

M305 P0 T100000 B4138 R4700 ; set thermistor + ADC parameters for heater 0

R4700. That is optional and not required as its the default value.

Kaizer

@Veti i see, Thanks a lot.

Kaizer

@deckingman Thanks for the help. it works fine now.

deckingman

@Kaizer Glad you are sorted.