Bltouch setup need help

Elvis0z

Think that I have P9 for the bltouch

Elvis0z

ahhhh ok don't understand gcode that well at all

JoergS5

@Elvis0z you will get used to it, it is not so complicated. One G-Code one line, the explanation is in https://duet3d.dozuki.com/Wiki/Gcode#main

It's only a bit complicated with the change from RRF2 to RRF3, because several G-Codes changed with the parameter meanings. Some were deprecated, some added.

JoergS5

@Elvis0z I know only one method to find the reason of the error: throw out parts of the config, test M98 again, throw out next until you find the reason. Throw out will be possible only for the parts which are not essential, like the heaters, fans, tools, miscellaneous. Then Z-Probe, Axis Limits. Please make a backup first!

Elvis0z

Will have a go

JoergS5

@Elvis0z I forgot: the forum here is the backup.

Elvis0z

Can I post a video here of what it is doing?

JoergS5

@Elvis0z most people make a youtube video and post the link here. Don't know whether you can post video directly, I suspect not.

Elvis0z

Ok I will try That

Elvis0z

https://youtu.be/Y6CVXsrzRvk

Here is the video of what is happening

JoergS5

@Elvis0z maybe its the
M203 X6000.00 Y6000.00 Z180.00 E6000.00
setting, because Z moves with maximum 3 mm/second, which will take forever at this distance on the video. Please set higher and try again.

PS the video was very helpful, this was a good idea!!

Elvis0z

should I put the same as x and y?

JoergS5

@Elvis0z you have trapezoid at Z, the stepper turns 5 rotations per second, your trapezoid has 2 mm for every rotation, so 10 mm/s, the value for Z should be 600 mm/min. The stepper could run 16 rotations/s maximum, but better be on the safe side.

Elvis0z

Thanks for your help.

Elvis0z

So just to make sure I have to home z before I can do anything else?

Elvis0z

Ahhhhh gets to the same point and deploys probe then nothing like in the video

JoergS5

@Elvis0z please see above, take 600. 6000 ist too much for the stepper.

JoergS5

@Elvis0z said in Bltouch setup need help:

So just to make sure I have to home z before I can do anything else?

the printer want to have homed all axes before it proceeds.

Elvis0z

G28

Error: Z probe was not triggered during probing move
Error: Homing failed

Just keep getting this error

JoergS5

@Elvis0z can you make a M122 after the G28 test please and show?

An does G1 Z10 and G1 Z-10 move as expected when you run this commands directly?