After updating to 3.4.0beta2: faulty heater 1, -273.1C.

CadetC

@dc42
yes -temp OK

dc42

Thanks. Please can you both try file Duet3Firmware_TOOL1LC-34b2+2.bin from https://www.dropbox.com/sh/heg82sqvhpqb670/AAARGaD-zLptgnHj-PiqiwQBa?dl=0.

PS - I've just updated that file because the version text didn't update.

Sotidii

@dc42
OK!

CadetC

@dc42
34b2+2.bin-OK

CadetC

@dc42

m122 b121.0
Diagnostics for board 121:
Duet TOOL1LC firmware version 3.4.0beta2+2 (2021-08-21 14:16:34)

dc42

Thanks to both of you. It appears that this bug has gone away as mysteriously as it appeared.

CadetC

@dc42
there is definitely a difference between firmware 3.4b2 and 3.4b2+2
below is a screen with temperature reading for 3.4b2 and below for 3.4b2+2 -

comparison made just now

m122 b121.0
Diagnostics for board 121:
Duet TOOL1LC firmware version 3.4.0beta2 (2021-08-03 10:00:09)
Bootloader ID: SAMC21 bootloader version 2.3 (2021-01-26b1)

m122 b121
Diagnostics for board 121:
Duet TOOL1LC firmware version 3.4.0beta2+2 (2021-08-21 14:16:34)
Bootloader ID: SAMC21 bootloader version 2.3 (2021-01-26b1)

But all in all, the most important thing is that it's OK now,

Thanks

jbarros

@dc42

Thanks!

Temps in range with the latest build so I give it Thumbs Up!

Duet TOOL1LC firmware version 3.4.0beta2+2 (2021-08-21 14:16:34)

And again, thank you for your time, dedication and work!

Marshal

Hi all,

I updated my printer after vacation and noticed the same issue.
I have upped the LC1 to 3.4.0beta2+2 and readings are back within expected range.

No recalibration done yet.

(I was not sure if there was a toolboard v1 reported or tested with the issue.)

Diagnostics for board 20:
Duet TOOL1LC firmware version 3.4.0beta2+2 (2021-08-21 14:16:34)
Bootloader ID: SAMC21 bootloader version 2.3 (2021-01-26b1)

Serge

@dc42 Hello, sorry, i don't have receive notifications from this post that you have make for upgrading the firmwares.
I have try the 3.4b2+2 and now, i have the hotend sensor offline.

Serge

Sorry for this mystake, i have reboot the Duet3 and now, the hotend sensor is online.
But :

Maybe i have to recalibrate the sensor ? yes or no ?
Thanks.

Serge

After recalibrate the sensor :

But now, stable.

pixelpieper

@dc42 Sorry for not following up further, I am currently on vacation away from my printer, but I am happy to try the builds when I am back in a week if it still makes sense.

dc42

@pixelpieper the problem appears to be solved in firmware 3.4beta3.