Tool board remote heater auto tune not implemented

[jdumoulin]

@Phaedrux I missed that. Thanks

[dc42]

Alternatively, follow the manual tuning instructions.

[bernie-mix]

Will that be built in at some point?

[Phaedrux]

@bernie-mix
Yes, the first step was updating the tuning algorithm, which is part of 3.2. Next step would be tuning remote heaters.

[ctilley79]

@Phaedrux Is that slated for 3.3 beta?

[Phaedrux]

@ctilley79 I don't think it's in the 3.3 that is currently available for testing, but it's planned to be there eventually.

[psychotik2k3]

@phaedrux
i just discovered this problem, and it's not only the tool board but also the expansion board 3HC. which will be pain in the ass now that i installed and wired my 3 tools on it (and they are short on wire so never be able to put them on the mainboard

could you mention this limitation on the documentation of M303 ?

[jay_s_uk]

@psychotik2k3 upgrade to the latest 3.3RC. Remote tuning is available and the release seems stable

[deckingman]

@psychotik2k3 said in Tool board remote heater auto tune not implemented:

@phaedrux
i just discovered this problem, and it's not only the tool board but also the expansion board 3HC. which will be pain in the ass now that i installed and wired my 3 tools on it (and they are short on wire so never be able to put them on the mainboard

could you mention this limitation on the documentation of M303 ?

This was fixed starting with firmware 3.3 beta1 around the beginning of March 2021.

[psychotik2k3]

@jay_s_uk @deckingman thanks for the info i will do that especially if the release is stable