topic_solved checksum foutregel 44/57
Kevin last edited by Kevin
i have sins a few days that my panel due i7 keeps saying conncting and dont find the sd card.
(does work via webcontrol)
all cables are checked and tightened
after a few times off / on it does it again
when I press home all it indicates
checksum error line 44
checkum error line 57
what could this be?
it sounds like a cabling error. Either the cable itself is failing, or it's being routed near other wires which are acting as a source of interference.
Are you sure nothing has changed in the configuration? What Baud rate is the PanelDue set to use on the Setup page?
At this point I think it would be prudent to replacing the cabling.
@phaedrux said in [checksum foutregel 44/57]
thanks for your comments i am going to order new cables.
I currently use stepper motor cable 0.33 mm² + -1.2 meter to board
I've watched it for a few weeks and haven't had any more mistakes.
replaced the cables and laid them along a different route
Good to hear you've solved it.