Is there a terminal like YAT for RPI?

tecno

How on earth do you get screen to connect to Duet board?

tecno

@phaedrux said in Is there a terminal like YAT for RPI?:

Ok. So you want to access the Duet terminal from the Pi? Now I understand.

You can follow this guide and use the instructions for Linux

https://docs.duet3d.com/en/How_to_guides/Getting_connected/Getting_connected_to_your_Duet

Sorry but not one word on how to with Pi

oliof

@tecno I am not close to my printers right now, but it's just the serial device as an argument to screen, so something like screen /dev/ttyUSB0 (the latter could be something else, check dmesg). Read the screen man page for other options like connection speed.

tecno

@oliof

OK ls /dev/ttyACM0 is there

screen /dev/ttyACM0
screen terminating

Sorry but this kind of terminal is real PITA

tecno

Managed to get CuteCom installed but no response on M115, only response I get is Error : VIN undervoltage when I power down.

Short.. Printer has been working for +48hours and I needed to change filament so I decided to take a brake for dinner and shut off the printer. After that I have no connection with the Duet board other than above Undervoltage message, no other commands work. USB terminal feels a bit wonky/loose.

Phaedrux

VIN undervoltage may just mean that VIN power has been removed but the duet is still powered by 5v via usb.

Where are you seeing the undervoltage event message?

tecno

@phaedrux said in Is there a terminal like YAT for RPI?:

VIN undervoltage may just mean that VIN power has been removed but the duet is still powered by 5v via usb.

Where are you seeing the undervoltage event message?

In CuteCom when unplugged power.

Anyhow this morning I get response to commands, have not touched anything from last night so go figure what was going on yesterday evening. Config.g empty 'again'.

chrishamm

@tecno minicom should work, too. It comes preconfigured for the Duet on DuetPi.

tecno

@chrishamm

OK, satisfied with Cutecom.

Phaedrux

@tecno said in Is there a terminal like YAT for RPI?:

Config.g empty 'again'.

Was this the original problem here or that it had happened previously?

tecno

@phaedrux

Both

Phaedrux

Had you edited config.g before it had gone empty?
Was config.g missing completely, or just blank?
Was config.g.bak present and complete?

tecno

@phaedrux

No
Blank
Present

Phaedrux

Thanks. Had we replaced this board for you already when it first happened?

tecno

@phaedrux

No config this morning, printer been offline for 2 days.

Today no config.g and no config.g.bak

re. board To be honest I do not remember. M552 S1 keeps me running

tecno

Here some moore

Now no CAN connection, WTF is going on??

jay_s_uk

@tecno i've seen that happen when i reboot. the board reboots before the toolboard can respond. its normal I think

tecno

Edited config.g (probe) and now CAN is back, this a bit fishy.

tecno

@jay_s_uk
; WAIT FOR CAN
G4 S4 should be plenty

jay_s_uk

@tecno the red line issue you showed above was after the emergency stop and not to do with startup