suche deutschen support für einen selbstentwickelten Großformat 3D-Drucker mit 4250 Watt DUET2 WIFI-Board. Sitze hier in München und bekomme meine PT100 daughter-boards bzw. die Heizbetten nicht angesprochen...könnte auch bei den anderen Configurationen Hilfe brauchen...

@droftarts thank you ian

@Phaedrux
I deleted all 4 lines... and what can I say... amazing speed!!
Thank you both
Many greetings,
Don

PS: New puzzles are just appearing again (progress display and filament consumption...but first the printer is running and I can devote myself to the insulation and construction space closure)

@günter-jibben Danke für den Tip!....da passt ja grad mal ein kleines Foto rein!

@PCR because I want to do live surveillance with a camera and not just individual images

@gloomyandy I actually got that wrong! Thank you very much and then I will follow the new instructions.
All the best!

@axiom Thanks to both of you! That seems to have been the solution!!!
Best regards

@cosmowave It works! Thanks, that was the solution!

I found a promotional video and I would like to know how to do it: hardware and macro...can anyone help me?: https://www.youtube.com/watch?v=yJo_1Op2g4Y

@jay_s_uk you are super! it works... thanks for your patience!

@dc42 Can't you adjust the speed somehow in g-code or in the macro?

How can I increase the speed of my bed leveling (G29).

@jay_s_uk No, i cant see it:

I built an optical light barrier as a filament sensor (see screenshot). The filament sensor also reacts when I put the filament in. But I want the error message with pause when the filament is missing, so the barrier is not interrupted. Nothing has changed about S1 and S2...is there another option?

@cosmowave and what do I have to write into the g-code so that it appears in the DWC and I can regulate it?

@dc42 I would like to be able to "play" with the flow (see cura screenshot) during the printing process

@stuartofmt Thank you for the answers, everything actually works if I simply copy the IP address from Motion....sadly my new raspberry 5 said goodbye after 1 hour...despite the expensive original fan and expensive power supply

Is there a way to call up a flow controller in the DWC to make corrections while driving (like speed)?

@Notepad Thank you very much, unfortunately I only have the option to install the plugin...perhaps the other options are no longer available in version 3.5.4?

I would like to use the motionwebcamplugin for the video transmission. But when I try to install it, I get a message saying that the Duet software framework is missing (see photo).

But since I don't want to switch everything to the framework (because I don't understand it), I wanted to find out if there is an easier way to integrate the video stream from motioneye into the DWC?