Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Is it also moving jerkily while it prints the curves? If so, that is a sign that you have the X and Y jerk set too low in the M566 command in config.g.
@genghisnico13 Fantastic. Thank you. I was worried I had a bad board! On to figuring out why my cold temps are so low..
@kep0a in windows you may be able to bridge the wireless and Ethernet interfaces
https://m.windowscentral.com/how-set-and-manage-network-bridge-connection-windows-10
