ok i have found my problem. i went through checking all of my wires and found one that i was getting it and miss reading from the hot end and it has a part of the wire severed in side if the wire covering. so i got it fixed and now it is working good.
Best posts made by Government_Bacon
-
RE: heater fault when print startsposted in Tuning and tweaking
Latest posts made by Government_Bacon
-
RE: Web controller reading 10° highposted in Duet Web Control
@JoergS5 I'm useing the duet 3 and the slice engineering high temp thirmister
M308 s0 p"temp0" y"thermistor" t500000 b4723 c1.19622e -
Web controller reading 10° highposted in Duet Web Control
I have a mosquito hot end with the high temp thermistor and I have it all set up but it is reading 10° higher than room temp I check it with a multimeter and it is fine.
-
RE: failed to parse major T-code number (he)posted in Duet Web Control
@Phaedrux it is the ending gcode i got rid of it and it is fine now
-
RE: failed to parse major T-code number (he)posted in Duet Web Control
@Phaedrux ok updated the firmware and the web-controller and i am getting the same error
-
RE: failed to parse major T-code number (he)posted in Duet Web Control
got the dwc updated will update the firmware now
-
RE: failed to parse major T-code number (he)posted in Duet Web Control
got this when i opened the jobs tab
i am using a SBC
-
RE: failed to parse major T-code number (he)posted in Duet Web Control
@Phaedrux im trying to but having trouble doing that i uploaded the new files but cant get them to install
-
failed to parse major T-code number (he)posted in Duet Web Control
started up my printer and now have this
using duet 3 dwc V 2.0.4 -
RE: Duet 3 motor wiring?posted in Duet Hardware and wiring
@infiniteloop its all good. i checked it just to make sure i had my steps right