Topics created by Government_Bacon

@JoergS5 I'm useing the duet 3 and the slice engineering high temp thirmister
M308 s0 p"temp0" y"thermistor" t500000 b4723 c1.19622e

@Phaedrux it is the ending gcode i got rid of it and it is fine now

@infiniteloop its all good. i checked it just to make sure i had my steps right

ok i have found my problem. i went through checking all of my wires and found one that i was getting it and miss reading from the hot end and it has a part of the wire severed in side if the wire covering. so i got it fixed and now it is working good.

@Government_Bacon said in X axis moves when Y axis is moves:

M143 H1 S280 ; set temperature limit for heater 1 to 280C

But the second port is also B4138 in your config.
also
M143 H1 S280 ; set temperature limit for heater 1 to 280C
is not good for a bed as a max temperature.

@Government_Bacon I would try reinstalling the firmware and Duet Web Control in case they are out of sync or have another issue.

As you can't connect to the web server, temporarily remove the SD card from the Duet. Depending on what board you have, copy the "Duet2CombinedFirmware.bin" (Duet 3 Wifi/Ethernet) or "DuetMaestroFirmware.bin"(Maestro) into the /sys/ directory on your SD card from here: https://github.com/dc42/RepRapFirmware/releases/tag/2.03
Also copy DuetWiFiServer.bin if you have a Duet 2 Wifi

Copy the "DuetWebControl-1.22.6.zip" contents into the www directory, overwriting what is there.

at the same time you can grab a copy of your config.g from the /sys directory and post it here so we can have a look.

Put the SD card back in, connect a USB cable and a terminal program like YAT, see here (https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7#s6)

And send M997 S0

If you have a Duet 2 Wifi then send M997 S1

Once they have completed you can reset the board and try the wifi again. You have now replaced all the firmware and the web server. If it still does not work, upload the config.g here

got every thing to work now thanks

Check the pin for any dirt or grime. It can get sticky. You can remove it with the grub screw on the top of the probe body. Clean it with some alcohol.

@mazdaspeed308 said in Web controller connecting issues:

hi when i put the ip address in to connect to that my Duet 2 Maestro is assigned, the web browser time out due to it taking to long. any help? ive followed the step by step process of setting board up for internet

Send M552 to the Duet over USB, and check that the message says that the network is running and confirms the IP address.

Test whether you can ping the IP address of the Duet from your PC.

ok got it working i think it was the tool changing part

Is there some one i can send it too or would it be better to fix it my self. And were would i find the parts.

I have this working on my machine:
M558 I1 P5 H5 F120 T6000