@PCR I'm in - Subject to costs (+Shipping)

@kingfisher
I actually think it might be my Duet wifi board causing an error. I've also got a duet maestro and running the same python settings on the maestro IP address hasn't resulted in the "('Connection aborted.', ConnectionResetError(104, 'Connection reset by peer'))" error

I've set it up and it works
I did get an error on a small print doing a quick test though
The error was "requests.exceptions.ConnectionError:

('Connection aborted.', ConnectionResetError(104, 'Connection reset by peer'))"

My guess (Although I'm not a Python expert) is that the pi couldn't keep up saving the images as the layers were only taking 20sec (And its an old V2 pi)

Thanks for sharing I. I'll try installing this in whilst in lockdown.
I had an idea to use a pi remotely to control RGB LEDs based on the printer status. (eg red = heating, white = printing, green = finished)
I might try and learn how to do this based on your code/logic

I use a magnetic sheet on my bed with a flex plate.
https://www.aliexpress.com/item/32987525330.html?spm=a2g0s.9042311.0.0.27424c4d4kVtAy
It started out as a temporary solution, but it's been working well and fairly cheap so it's still in place and I've never got round to adding proper magnets

I have a couple of these: https://www.aliexpress.com/item/4000145002586.html?spm=a2g0s.9042311.0.0.aff14c4dDnCFRA

I'm very happy with them so far, however even though its spring steel it will still move/flex if only held on by clips. I tried this first before moving to magnetic sticker sheet as a temp solution (It might lose magnetic strength due to the heat over time, but a month in its holding up well)

if/when that fails I'll look at adding permanent magnets under the bed

Thanks I just added it, (But I've only tested the idle state this evening)
I'll try and add a second printer next week.

Thanks - Looks clean and simple
I'll add this to my magic mirror over the weekend and let you know if I have any issues.

Do you have an M190 in your start g-code?

@dc42 The new LCD arrived today and the pins on the new board were in the above orientation when I tested it with the meter, I plugged it in and it works perfectly

I think the old one was an MKS one from Ailexpress and as you suspected the pins were rotated.

It might be worth adding a warning on the wiki ensure others don't have the same issues (But in my case no long term damage was done)

Thanks again for the support in solving the issue