hello

FDM/FFF Printers are getting faster and faster by every week in the community.

Carbonfiber rods, Mosquito magnum+ with almost 100mm3 flow allows for extremely fast extrusions even with small nozzles.

Printing large objects fast generally isnt a problem. But once small detail is introduced (benchy roof pipe for example) that requires lower speed for cooling, or lower speed for the fine details.

So what if we could type in the Slicer:
Detail temperature
Speed temperature
Heater VIN readings (to accruately time the temperature changes)

Slicers already have Minimum layer time for cooling. But when I print PLA at 280Celcius to match the flow, that is just waaay to much for that benchy pipe.

So if the slicer could set temperature to 210C some time before the pipe comes, the printer could gradually slow down the speed match that temp.

at 280C it runs 300mms
at 250 it runs 200mms
and at 215 it runs 60mms (just exampes)

That way we theoretically would get a perfect benchy at the highest possible speed.

Thoughts on this?
am I being uselessly creative here?

best regards
jhb

Hi
https://duet3d.dozuki.com/Wiki/Duet_2_Pinout_table

is there a new site replacing this site? or does anyone have the pinout table?

best regards

Ok i was printing a thin piece of sheet at

first layer 60mms.

once I saw good adhesion i increased 300% to 180mms

PRinter is configured to run at maxium 400mm/s (24000mm/min)

However, once I Resumed the print, it used the previous 180mms as 100% and now ran the printer at 540mms.
So there are 2 bugs. First is that it used the old speed values to set new 100% value, and second is that it printed above the hard-coded configured speed.

I Tried to revert it by setting the speed to 33% -> Pause -> resume -> speed 100%
it now ran 60mms again as base speed.

Version 3.4.0 B3

@mfs12 thank you

hey
running latest versions of beta 3.4
latest version paneldue and latest DWC

When I plug in the SD into the Paneldue, I have to detect it first via the DWC by pressing SD card #1
If i dont do that it never shows up on the SD card list on panel due.

@o_lampe thank you:)

@o_lampe Yeah maybe ill just try the DSH that arrived yesterday. that one says
2304 - DSH - YP3HC"

Do you know the orientation of the purple LISD3DSH board? X Y Z
I cant find that information anywhere

@dc42

8937
c3H
0KK1F?

@tekstyle thats smart! i will try that

@phaedrux

@jbergene Now I get another issue and that is the Duet2 just reset every time I try to record. It some how manages to record something, but the CSV file is invalid.

Duet also states that the LISD3H is aLIS3DSH which is incorrect. (the board have LIS3DH typed in on it)