Topics created by Colin Kent

@colin-kent said in Problems going beyond 550 in Y direction after firmware update:

I changed the g92 to read X550 Y770 Z94 and that cured my problem. Looks like it over rides the M208 in the config.g.
I will call ooznest tomorrow to see what its there. Thanks for the guidance, I wouldnt thought of looking at homeall.g

The G92 command should not be there at all. I suggest you remove it.

For those interested in changing post processor for Vcarve. I got this instant reply from Vectric

You cannot use " marks in the list of commands as these are used to tell the software that this is where a line begins or ends.

On Page 28 of the Post Processor editing guide this is described in more detail.

For example the line:
M291 P"Have you set work coordinates ?" S3.

is replaced with

"M291 P[34]Have you set work coordinates ?[34] S3."

Thanks Vectric for that.

Have just checked all the endstop wiring and made sure that it wasnt in a position where it could get caught. checked each home position separately and did Home All and everything is now fine. Looks like you are right. Thanks very much.

I think Oozenest is working on an update for RRF3. May want to check with them to see where they are at with that.

I Have found the socket on RS. I have the tools, not sure about my eyesight but will have a go I think