Greetings --
I recently received an additional Smart Effector (I have 2 already) and when plugging it in to existing connections, the z-probe hit doesn't register.
In my general debugging, I swapped out the new one with one of my existing Smart Extruders and there was no problem -- the Z-Probe and all electronics worked as expected.
I'm assuming that this Smart Effector is defective, but I'm told by my distributor (Filastruder) that I need to post to this forum to authorize the exchange. Are there other steps I should attempt in order to get the hardware running? I didn't have to go through it with the other ones...
Thanks in advance for your support.
