Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Dave1167
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 5
    • Posts 7
    • Best 0
    • Controversial 0
    • Groups 0

    Topics created by Dave1167

    • Dave1167undefined

      Duet 0.8.5 and BLtouch 3.1

      General Discussion
      • • • Dave1167
      2
      0
      Votes
      2
      Posts
      124
      Views

      dc42undefined

      @Dave1167 said in Duet 0.8.5 and BLtouch 3.1:

      Am I correct in thinking I can go ahead and connect the probe to the 0.8.5 Z probe socket without any additional resistors or diodes etc.

      It should be safe to connect the BLTouch black and white wires directly to the ground and IN pins on the Z probe connector. You will need to supply +5V power to the BLTouch, and you will need to connect the BLTouch control input to a PWM-capable output on the expansion connector.

    • Dave1167undefined

      Problems with mini height z probe

      Duet Hardware and wiring
      • • • Dave1167
      7
      0
      Votes
      7
      Posts
      942
      Views

      redundefined

      thanks david…. i will, but i still want to figure out whats causing it. ill get back with updates

    • Dave1167undefined

      Mini height sensor

      Duet Hardware and wiring
      • • • Dave1167
      7
      0
      Votes
      7
      Posts
      934
      Views

      Dougal1957undefined

      Also looking at the spec of it it has a sense range adjustable between 3-80cm

    • Dave1167undefined

      Heater 1 not working - Duet 0.85 new installation

      Tuning and tweaking
      • • • Dave1167
      5
      0
      Votes
      5
      Posts
      858
      Views

      Dave1167undefined

      Thanks, I'll put the T0 into the config.
      My intention is to use the web interface, but I print in a garage and my WiFi signal is weak. I haven't got a network cable in there yet. I am looking to use a WiFi extender, but I'm keen to get my 3d printer back up and running again. Anyway the advice dc42 gave me has fixed the heater problem. So time to get steppers working now.
      Thanks again

    • Dave1167undefined

      Duet 0.85 2 z axis stepper motors

      Duet Hardware and wiring
      • • • Dave1167
      3
      0
      Votes
      3
      Posts
      745
      Views

      deckingmanundefined

      …............and don't forget that the Duet Wifi already has two Z motor connectors which are wired in series.