I am so eagerly waiting to here more on this, I run 2 Duet3s with bltouch, and I am running out of spare tips
Best posts made by DeadNewbie
-
RE: New Z Sensor?
Latest posts made by DeadNewbie
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
@dc42 Thanks, I am still snowed under, but hope to take a look tomorrow, I will update asap.
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
just got back to this, been busy moving my kids home after university.
-
RE: Scanning Z probe support in RRF 3.5
very interested in this, can you stick me down as a beta tester if you want one.
regards
Michael
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
well, I got further, I ended up moving X and Y to the Expansion board and moved all 3 extruders to the 6HC.
i no longer get the error, but it doesn't move anything when I issue the
G1 H1 E400 F6000I will upload config.g later along with m122 and m122 b1.
what am i looking for in the m122 output to determine if the stepper is already stalled?
Thanks again for the help.
Michael
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
Thank you both, that would do it, I will move it back to the mainboard and retest.
Regards
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
@dc42 the extruder stepper is the MT-1701HSM140AE slimline E3D, I get the odd stall detected when in use, so there is a little fine tuning left.
But I cant seem to get the G1 H1 to work.
regards
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
@dc42 mb6hc with exp3hc I also have a toolboard, but I am just using that at the minute for the acceleration module.
Thanks for looking.
just in case it helps, all 3 extruders are on the expansion board.
-
RE: enable extruder endstops error when using G1 H1 E400 F12000
Really struggling with this, now using 3.4.6 RC1 and still the same.
Anyone?