Topics created by Duckle

That was indeed it. Thanks 🙂

Thanks. That's my desired behaviour for now anyways 🙂

Hmm, okay. I'll keep hunting the mysterious layershifts then 🙂

;E0 worked. Thanks 🙂

@dc42 This is, in fact, a Low-pass filter, a 2nd order one in fact (yeah not necessary) it's just buffered by an opamp, and the current is carried by a MOSFET 🙂

A different option could be a low-pass with a series-pass transistor. that should be smaller than this board 🙂

Hi,

I am looking for Maestro 3D model for the purpose of designing a case.

Have you finished your model? Can you share it with the community?

🙂

Microstepping is supported per driver. When the firmware executes M350 it automatically adjusts the steps/mm to account for the change in microstepping.

What mode do you have the extruder driver running in? If it's in stealthChop mode, try spreadCycle. See https://duet3d.dozuki.com/Wiki/GCode#Section_M569_Set_motor_driver_direction_enable_polarity_and_step_pulse_timing.

btw there is a more recent version of the web interfacer than the one you are using.