Topics created by Duetfan223

Excellent, thank you!

I managed to get it working again, though I may have been 1 layer off, its at least printing now and seems to be doing a fine job sticking to the previous layer.

https://forum.duet3d.com/topic/4778/restart-print-at-specified-layer/3

So in the end, the M26 S number for your corresponding line is found in your gcode file by opening your G-code file in Notepad++ and ticking "Offset"

After this print, I will try the m110 command on a test piece, thank you Anzere

M143 H1 S320 sets the max temperature to 320

I added this to config.g just before the extruder PID section and it seems to work

When I run M303 H1 S320 it completed successfully, I added it's suggested PID values to config.g

The next print came out perfect, and there we no heater faults.

So the answer in this case is add M143 H1 S320 to the config.g file and auto-tune the heater with M303 H1 S320.

https://duet3d.dozuki.com/Wiki/Gcode#Section_M109_Set_Extruder_Temperature_and_Wait

@dc42 said in One-press resume printing after power failure:

There is no guarantee that the Z hop in your power fail script will be completed, because the power reserve might run out first.

Yes - I'm fully aware of that. But I feel like taking a risk today 😄

My mistake, I misread the description of firmware I found on Google and installed duet2combined firmware. Was supposed to install the "reprapfirmware" for my 0.8.5 instead. D'oh! Problem solved.

I understand now,

https://duet3d.dozuki.com/Wiki/Firmware_Overview#Section_Duet_Generation_1_Duet_06_and_Duet_Num_085

*Duet Generation 1 (Duet 06 and Duet 085)
Firmware files for older boards are currently also at https://github.com/dc42/RepRapFirmware/r....

The main firmware is RepRapFirmware.bin
The web interface is DuetWebControl.zip*

I think I may have been following different set of instructions, thanks for your help elmoret

Problem solved!

It turned out it was indeed a loose or broken wire crimp connection on the stepper's blue wire, right at the Molex connector.

I'm amazed it printed properly for as long as it did...

Thanks for all the help.