Thanks for the help, it is working now.
Best posts made by eduard
Latest posts made by eduard
RE: No DCS after firmware update on Duet3 (3.2b2)
@Phaedrux Firt of all, thanks for the help!
I did not want to try instable version, just under the beta was not indicated it is an instable version. In most cases, the beta is just a fixed version.
After I realized, there is a stable release, I stick to that.
The documentation is very fragmented, and unprioritized. In point of setup unnecessary things come first, and important one are follows. A guideline is missing, even if I made the setup several times, after a year or so, is hard to to pick up the thread. Duet can act like an idustrial equipment setup guide to prioritising the setup process with one entry point.
The drawings has to be on one place for all the boards: schematics, connection diagrams, topology, and firmwares. The fw files has to have the version numbers in their names!
Just check the macros, they are very important and are hidden somewhere in the tree. And they are also not settled.
these are just thoughts...
Anyway, thanks for the hard work, it is a good hw sw.
No DCS after firmware update on Duet3 (3.2b2)
afterupdated the fw to latest 3.2beta2 on Duet3 the local webpage not appearing. The firmware update made on BOSSA from a PC, and verified.
The DCS diag output is here:
Please help. The lacking of documentation on Duet3 is very frustrating.
RE: New power output for toolboard
Thank you for your answer, I'll keep in mind while designing the servo control pcb. Perhaps a supressor diode will do the job.
How can I drive the servo from G-code? The is already a macro for servo drive? (0-180 degree control, or mapping command)
New power output for toolboard
Hello, may I have some help to control a new power output on duet3 Tool Board 1LC v0.6 for a second heating element?
I build a mosfet darlington based on OUT_0 in toolboard schematic and connected to the tool board ATSAMC21G18A pin PA16(25).
My question is, how can I address this pin and add a function to it?
Thank you for the help.