Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Gear
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 5
    • Posts 18
    • Best 0
    • Controversial 0
    • Groups 0

    Topics created by Gear

    • Gearundefined

      enclosure fan for heated chamber without a chamber heater

      Duet Hardware and wiring
      • • • Gear
      11
      0
      Votes
      11
      Posts
      669
      Views

      deckingmanundefined

      @Gear To expand on that, my slicer start code does nothing more than call a pre-print macro and the end code does nothing more than call a post-print macro. All the temperature settings are disabled in the slicer. The macro do it all. The reason for that is it gives me much better control over the order that things happen. So rather than setting the hot end and bed temperatures then waiting for them before anything else happens, I heat the bed to about 40 and wait. Once that threshold is reached, I start heating the bed to it's final value but while that is happening, I start heating the hot end and home all axes. The net result is that everything that needs to be done before a print starts, happens in the time it takes to heat the bed. I use different macros for each filament type. So if I print something in PLA,but then want to print it again in PET-G, I simply edit the gcode file to call a different macro. No need to re-slice.

    • Gearundefined

      Pressure advance tuning

      Tuning and tweaking
      • • • Gear
      10
      0
      Votes
      10
      Posts
      1.7k
      Views

      Gearundefined

      @dc42 @deckingman i'm running an 0.4 nozzle, I tried deckingman his method with petg and this is the result I got on

      M572 D0 S0.2

      S 0.2

    • Gearundefined

      Bondtech BMG owners what are your accel and jerk settings?

      General Discussion
      • • • Gear
      11
      0
      Votes
      11
      Posts
      10.0k
      Views

      deckingmanundefined

      @burtoogle said in Bondtech BMG owners what are your accel and jerk settings?:

      I don't think it is very noisy. The Titan I had before was much noisier, it went clack, clack all the time but the BMG is quiet.

      That's exactly what I found too.

    • Gearundefined

      underextrusion after travel

      General Discussion
      • • • Gear
      4
      0
      Votes
      4
      Posts
      498
      Views

      Phaedruxundefined

      Start with the recommended values here: https://duet3d.dozuki.com/Wiki/Pressure_advance

      It will depend on whether you have direct drive or bowden for how much you'll need.

      My preferred way to calibrate it is to print a rectangle with normal slicer settings and then watch the print while increasing pressure advance slightly every few layers and noting the changes.

      You may want to update to firmware 2.02 now that it's out.

    • Gearundefined

      Issues with extruding after retractions

      Tuning and tweaking
      • • • Gear
      11
      0
      Votes
      11
      Posts
      889
      Views

      Wyvernundefined

      Try extra prime?