Topics created by greecher

You never need to go through multiple versions when upgrading firmware. The upgrade from 1.18 to 1.19 was more complicated than usual because functions that were previously running on the WiFi module were moved to the main processor so that we have more control over them. This required the interface between the WiFi module and the main processor to be completely rewritten so it wasn't possible to maintain backwards compatibility either way round.

DC42,
man you do a bang up job, thanks for the info, put it in will try it out.

dave

No problem, if I saw "Tools / Heaters / Extra" mentioned, I would assume that the"/" meant a sub-menu. But in this case, it didn't.

0.01? Are you saying you need 10 microns adjustment resolution on your first layer? Maybe if your first layer is 50 microns thick… I can see the change of 50 microns per babystep with the current setup at 0.3mm first layer height but much less and you won't know if its getting better or not unless you press it 3-4 times, in which case might as well leave it set to 50 microns.

Just my twopence worth. If its configurable I'm good with that.

Indeed beneath timelapse everything else is working 😉

WebCam-Integration and also (in my case) direct Upload of GCodes from Simplify3D.

I've used Octoprint and Repetier-Server before too, but with my DuetWifi/DuetX5 and also my Radds (with an additional ESP286) i'm using nothing else as the WebInterface.

For the WebCam i'm using a Raspberry Pi 3 with MotionEyeOS, where i always save the Video-Stream and inside the WebIf i'm using the live-video Feed.

Cheers
MoS-tekknix

They will be much better on 24V than on 12V, but you may still be unable to reach high speeds. See https://duet3d.com/wiki/Choosing_stepper_motors#How_to_work_out_the_power_supply_voltage_you_need.