Ok, thank u.

Ye, Thanks.
But I'd have to go beyond the end stop

Hello,
is there any way I can turn off the Z-enstop? Or tell the per Gcode command that Z is homed?

Ok,
now i get the temp. but the extruder don't work and i get this Error:
Error: Attempting to extrude with no tool selected.

Hello,
I can't print anything I sliced with Simplify.
I always get the following errors:

Tools at Duet:

Settings in Simplify:

Can someone help me?

Thanks

ok, I had to disconnect the whole power supply to the board (also USB). Then it worked. Thank you

So i added this in the config.g
; Tools
M563 P0 D0 H1 ; tool 0 uses extruder drive 0 and heater 1
G10 P0 S0 R0 X0 Y0 ; set tool 0 temperatures and offsets

Shouldn't this now also be displayed under Tools in the dashboard?
Cause it doesn't show anything.

Hi,
Thanks i will test it.

Take a look at the pictures, where always "Werkzeug 1" is written you can choose different ones (0-5)
Which sliver do you use?

And why is that?
I didn't set anything of a tool 5 in S3D and in Duet I created the tool.