Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Ok, thank u.
@Gummix The duet firmware requires a tool to be selected before you can extrude, even if you have only one tool.
Place a T0 in your config or Simplify3D start script and it should fix that error.
Hi, thanks i will give it a try.
ok, I had to disconnect the whole power supply to the board (also USB). Then it worked. Thank you
U are right.
Thanks
O crap. U are right.
