Topics created by Hernicz

@Hernicz I agree that it would be better to start unloading only as soon as a filament is selected and I'm going to change DWC in the next 3.6 beta. But note that for non-MMU setups, you actually need some time between unloading one filament and loading another, otherwise it would eject the filament and then load it again immediately. So I think an optional confirmation prompt between unloading and loading is necessary.

@dc42 I tested Secondary Dive Height as well and it's wonderful, but it disables Secondary Dive Speed.

Such a high count of probe points is almost begging for a 3D-scanner like setup. With cameras and flashlights you can produce a cloud of millions of probe points in no time...then filter out the polygone-planes that are equal to the neighbours to compress the file.
Some smartphones can do that too. Maybe add a phone gimbal to the printer and let the smartphone scan the bed...

Can you send M122 and copy and paste the results here?

There should be some extra checks in 3.4.4 to prompt before a 0kb file is saved.

ok the geometry and type of material affect the pid adjustment

@dc42 Agree and in any sequence it should work like that, but in case a single G30 command is entered in console I think it's better if the probe type is reverted to P9 (basically this is the only reason I made it in a way that it defaults back to original behavior).