Topics created by Icthus

@Icthus:

Thank you very much darookee, can I ask what setup you have as well?

My printer is a HyperCube-y CoreXY using the extruder of the Wanhao i3 I ripped apart…

Thank you! Turns out it was a combination of two things! Added the H1 and it was a dodgy crimp on the connector!

@Icthus:

…...............I'm got movement starting to happen on the printer but it looks like the z-axis keep skipping steps and I've just upped the mA to 1800!

Some possibilities. Something binding or sticking? Z speed set too high or more likely acceleration set too high? Incorrect steps per mm? Not familiar with that printer so can you explain the configuration of the Z axis (number and type of lead screw, motor arrangement etc).