@ignacmc @jay_s_uk @Phaedrux @T3P3Tony @dc42
FINAL Update: I have updated firmware from 3.4.5 to 3.5.0 beta 3 and the error no longer happens, so it definitely seemed to be a bug in 3.4.5!
BTW, My Duet3 Mini5+ is a FYSETC clone.
YIPEEEEE!!!!! 
Best posts made by ignacmc
-
RE: "Error: Probe was not triggered during probing move"posted in Smart effector for delta printers
-
RE: "G28 Error: G0/G1: insufficient axes homed" after months of useposted in General Discussion
@dc42 David....you are a father to me! It did the trick...
Stupid me, I forgot I have made that change a few days ago while researching here how to tune Stealthchop and didn't print since then so I was not aware of the problem I had just created.
Today in Spain is the Fairy Kings day, when tradionally Christmas presents arrived. This has been a very nice one!
Thanks for your outstanding support!
Ignacio
-
RE: Eccentric Probe on a Delta Printerposted in Duet Hardware and wiring
@jay_s_uk Noted!
I would like to know the experience of a BLTouch Delta Printer owner just for curiosity.... -
RE: SmartEffector DeltaCalibration: Z probe readings not consistentposted in Smart effector for delta printers
@dc42 Yes, Now I don't have any problem with G32. the sensivity was probably a typo of the guy who send me the config.g. Changed to 0.02 and now it runs perfect
-
RE: "G28 Error: G0/G1: insufficient axes homed" after months of useposted in General Discussion
@jay_s_uk Yes, I have been printing with these config files for months without issues. I suspect some hardware problem. As I was going to replace my LDO 0.9 motors for OMC equivalents, I will do it and recheck all wiring at the same time...
-
RE: Hot-End Thermistor Temperature calibrationposted in Tuning and tweaking
@jay_s_uk Think I will be getting one and ditching the NTC100K....I suppose it does not have any disadvantage over a thermistor even at low temps
-
RE: Eccentric Probe on a Delta Printerposted in Duet Hardware and wiring
@arnold_r_clark Thanks Arnold...your very clear explanation adds to jay's one...I think is time for getting another SmartEffector. Or doing fully manual calibration with the nozzle tip ignoring the inductive sensor...
-
RE: 0.9 deg/step Motors for a Delta (Anycubic Predator)posted in General Discussion
@dc42 Thanks David. I will order them inmediately.
The fact is that I have a Duet 2 Wifi installed on the printer and a Duet3 Mini5+ waiting on my desk. Wondering if 2209 vs 2660 worth the effort to do the transplant.... -
RE: Using 0.9 deg LDO motors in StealthChop mode on a Deltaposted in Tuning and tweaking
@ibash Wow! Thank you very much for your detailed explanation. It exceeds my expectations and I believe it sets me in the right direction to tune my delta. By the way and seeing that LDO 0.9 seems to not get along very well with TMC2209, I have ordered 3 OMC 17HM19-2004S1 for replacing them...I will report with my findings
-
RE: Best Choice of Motor for a Delta Printerposted in Duet Hardware and wiring
@bberger My idea is something like this:
I can send you the Fusion360 files if you want. I intend to place some steel tape on the towers and some embedded magnets or magnetic tape on the enclosure panels