Topics created by Maut

@garis Linear advance or pressure advance? https://duet3d.dozuki.com/Wiki/Pressure_advance

@simplesimson said in IR probe and Duet Maestro:

Hey,

i´m still having the same problem. Do I need to use M558 P2 for the "digital probe"? if I do so, the Probe Z status in DWC shows 0 (5) when not triggered and 0(1000) when triggered. By Triggerd i mean a red LED.

Sorry for the late response. M558 P1 is correct for the IR sensor that we sell. P2 is only for the sensor that RepRapPro included in the Ormerod 2 printer and I think also the Huxley Duo and one of their Mendel printers.

2.0 on the Maestro is equivalent to 1.22 on the 085.

Yoir motor currens are ok for the Maestro but as the extruder is set to 1.3A I recommend fan cooling. A fan at the edge of the Duet blowing cool air along the line of drivers on both sides of the board is good.