Topics created by MediaXYZ

Thanks for the advice.

Even though this Duet 2 Wifi card is pretty old (having come to me out of a different printer that was headed to the scrapheap), it seems to be new enough to have a fan fuse.

Although it looked ok, putting my multimeter across the fuse blades showed it is kaput.

I’ll swap it out and see how we go.

Thanks again

Yes - I can confirm that by “set correctly” I mean that there is no jumper.

I’ll have a look and see what I can figure out, but to be honest, I’m a bit dirty that I only just got this printer built, working and dialled in, and now I have to pull it apart again just as I got to the fun bit. 😞

That said, I’m happy with the Smart Effector, except for this failure. I think it has become an essential component in any decent Delta build.

@droftarts I think I got the probe working. Not really having any better ideas, I inverted both the z probe in pin and the z mod pin in the cogfig.g. When that didn’t work, I inverted just one pin at a time. Apparently having the mod pin inverted did the trick, and it works, although I have absolutely no idea why that is the case.

I also plugged in a spare thermistor directly into the board and it worked fine, so I’ll do a little fault-finding. Perhaps it is a bad sensor...