Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. minim
    3. Best
    • Profile
    • Following 0
    • Followers 0
    • Topics 18
    • Posts 155
    • Best 6
    • Controversial 0
    • Groups 0

    Best posts made by minim

    • RE: Filament runout sensor using DC42 IR probe

      I'll give it a go 😄 First sensormount was having the filament to close but It seems that it will work if I move it out 1mm.

      alt text

      posted in General Discussion
      minimundefined
      minim
    • RE: Anybody using a Duet board with a Klipper SBC?

      @gaweyo It was a bit easier from a pc than from my phone 🙂 I have some issues in the Z axis after a crash during config but it still shows great improvement of ringing in the lower print with input shaper enabled. Upper print is without input shaper. Both are done with 1500mms accleration increasing each 5mm up to 7000mm/s accleration and the print speed is 100mm/s.

      161295168_10164807339180234_381545447153503559_o.jpg

      posted in General Discussion
      minimundefined
      minim
    • RE: Duet Wifi config on a Flashforge Creator Pro

      This is the Z stepper.

      http://www.flashforge-usa.com/shop/parts-accessories/z-axis-motor.html

      Edit; found this info on a makerbot 1, sounds a lot better now. will measure heat after a while

      The MCP4018T-502E/LT digipots value is set to 118 for X, Y, A and B which gives Vref 1.75V (810mA max.), and 40 for Z which gives 0.60V (278mA max.).

      Edit2; this solved my heat problem just to reply incase anyone else comes across this.

      posted in Tuning and tweaking
      minimundefined
      minim
    • RE: Where's the Duet Wifi 3?

      I'm also waiting for the duet wifi 3. No interest what-so-ever in a raspberry pi for this application. KISS is gone out the window it seems. I want to upgrade my printers but until the duet wifi 3 is out there just isn't any point at all.

      posted in Duet Hardware and wiring
      minimundefined
      minim
    • Filament runout sensor using DC42 IR probe

      I got many IR probes lying around and I was wondering if anyone ever tried to use these as filament runout sensor? Is it possible to lower the sensitivity enough to be able to detect filament missing?

      posted in General Discussion
      minimundefined
      minim
    • RE: warning z=0 datum was not determined

      you also get that message if you home against limit switches (for example on a delta at the top) without homing with the Z probe. My Z switches on my delta is good enough for me not probing with BLtouch each time so I get that each time I don't do a probe run before loading the height map. It's not a error it's just a warning telling you that the height map is based on the Z datum set with the probe and not the limit switches you home against.

      posted in General Discussion
      minimundefined
      minim