@o_lampe great thanks I will look into it

Re: Converting CreatBot D600 pro to Duet3D

Hi. I 'm trying to restart the post regarding converting the creatbot D600 to DUet3D. Anyone who could tell me in steps what to do? I just bought 3 of these machines but the UI and Firmware is still not good enough.

@dc42 but the fan did not work until I put a jumper in the one I am pointing. I also have nema 17 12v motors connected and they did not work either but now everything work with the jumper in? Thought I knew why. Sorry if I do not understand your comment.

@dc42 but as said it seems to work now with a jumper in 12v for fan and a jumper in for the board. Thought I could run 24v on board and just set a jumper in 12v for fan.

@dc42 Yes I already did that, but there were no jumper in the one just beneath the 12v output (my finger point). I am running 24 v on duet mainboard.

Hi @dc42 and @deckingman. I think I figured it out. My mainboard is running 24 volt and I thought I only need to set jumper in 12v fan for running the fan in 12v but it turns out that I also need to set a jumper in so everything runs 12v. Have I understood this correct?

@Phaedrux said in Help with Fan - simple question - M106 and M950 Duex:

M106 P5 S1 H-1

Nothing happens. It is just "accepting the command". The fan is 12 v and the jumper is set to 12v. It is weird because the fan definitely work as I tested it on the duet fan0 and here it worked perfectly with

M950 F0 C"fan0" Q500
M106 P0 S1 H-1

I tried to change the jumper to another one but nothing change. I also tried fan.duex3/4/5/6/7/8 but nothing is working.

@Phaedrux said in Help with Fan - simple question - M106 and M950 Duex:

H-1

No. It still doesn't work. Any other suggestions?

Hi. I'm new to Duet wifi and I'm trying to get this to work. Need a fan that is always on from the duex 5 but can't get it to work. I've tested the fan in the duet wifi fan always on output and it is working fine. I've also tested all the fan output at the duex but can't get it to work.

What do I do wrong?

;define fan for duex5 (fan05)
M950 F5 C"duex.fan5" Q500
M106 P5 S1.0 ;fan5 always on

@droftarts Aahhhhhh
Thanks a lot. It helped!