@generisi I do got one , HG-C1050 about $150.

Hello!

is it possible to use laser distance sensor such as PANASONIC HG-C1050?

it have a 0-5V output, if yes we can get a bed mesh without Z motion.

Thanks !

I want to use 9 external motors in Duet2 wifi, now i can get 5 through breakout borad and 2 through CONN-LCD

but not enough ..

I want to use main board's E/D/S , but E signal doesn't works because 2660 works with SPI mode , I know it's not good to use this..

So.. Other way to use external motors with main board, or how to close 2660 SPI ..

Thx !

@Phaedrux Thank you , Is this OK?

@Phaedrux /www or /sys
I have upload the newest www files

@Phaedrux I use 2.07 zip
but in web it show 2.04..

I have already use CRC

On Duet2 Wifi v1.04

Sometimes upload files on web would be garbled.

Once I edit config.g, Sometimes upload Gcode Files..

like this...

My firmware is rrf 3.0

sorry...
I have link all sign- to gnd ...
now it works well

I want to get 4z in my machine, but duex5 is too expentive for me .
so i use Expansion Breakout Board and Pololu driver..
as this .. https://hobbycomponents.com/motor-drivers/892-breakout-board-for-a4988-stepper-motor-driver

and I link dir+, step+, enable+ to board's S,D,E, link all signal+ to 24V-
but now , the breakout board is too hot ..
I guess because the signal- are 3.6V-, but how to resolve it
I want to Use Berakout Board to make wires clean

@Danal

yes , it can be home correct

also can up 10mm

but when i do G1 X100 Y0 Z10, it reports outside limits... but it should reach it ...

so.. anywhere config wrong? which config affect it ?