Posts made by netuser

@generisi I do got one , HG-C1050 about $150.

Hello!

is it possible to use laser distance sensor such as PANASONIC HG-C1050?

it have a 0-5V output, if yes we can get a bed mesh without Z motion.

Thanks !

I want to use 9 external motors in Duet2 wifi, now i can get 5 through breakout borad and 2 through CONN-LCD

but not enough ..

I want to use main board's E/D/S , but E signal doesn't works because 2660 works with SPI mode , I know it's not good to use this..

So.. Other way to use external motors with main board, or how to close 2660 SPI ..

Thx !

@Phaedrux Thank you , Is this OK?

@Phaedrux /www or /sys
I have upload the newest www files

@Phaedrux I use 2.07 zip
but in web it show 2.04..

I have already use CRC

On Duet2 Wifi v1.04

Sometimes upload files on web would be garbled.

Once I edit config.g, Sometimes upload Gcode Files..

like this...

My firmware is rrf 3.0

sorry...
I have link all sign- to gnd ...
now it works well

I want to get 4z in my machine, but duex5 is too expentive for me .
so i use Expansion Breakout Board and Pololu driver..
as this .. https://hobbycomponents.com/motor-drivers/892-breakout-board-for-a4988-stepper-motor-driver

and I link dir+, step+, enable+ to board's S,D,E, link all signal+ to 24V-
but now , the breakout board is too hot ..
I guess because the signal- are 3.6V-, but how to resolve it
I want to Use Berakout Board to make wires clean

@Danal

yes , it can be home correct

also can up 10mm

but when i do G1 X100 Y0 Z10, it reports outside limits... but it should reach it ...

so.. anywhere config wrong? which config affect it ?

Thank you !

I'm sorry.... i just have some trouble...

it's my delta config:

R = 193.65
La = 287.5
Lb = 674
r = 102.46

And this is my M669

M669 K10 U287.5 L674 A-60:30 R91.19 H600

it can trige stop correctly, but it can't reach (100,*,0) or more far position , but it should reach it , and it not reach it's max angle

my stop is higher 30° then level..

I think level is 0°, is it correct ?

@dc42 OK, I'm being done

In M669, What's Meaning of Rrr and Hxx：yy：xx

i used two radiuss of Static platform and Moving platform past... it's hard to understand Rrr and Hxx...

and any plan to support auto level..

Thx!

Thx! looks Great !

Is it available now ?

I make a delta robot , and want use it for printing ...

but how to do it ... Is duet support it ?

looks like this

1. Is reprep support it ?

2. If it support , what i should do

3. If it don't support , what i should do if i want use it for printing...

Thx ！

@elmoret china

I can't find it in github...

so ....

anyone can tell me where to find duet3 schematic...

and i plan to buy duet2 wifi or duet3..

but ... delivery policy doesn't support in my country ..

thx very much !