Topics created by Phantom329

@Phaedrux said in Printer goes past endstops:

Is it actually homing?

Can you send M581 T1 and report back with what it says?

You may also want to upgrade your firmware to 3.5.3 so that we're on the same firmware page.

M581 T1 Trigger 1 fires only when printing on a falling edge of endstops/inputs X Y

It homes like normal. I updated my firmware to 3.5.3 and no change.

@jay_s_uk I finally got it through bossa. Weird that it wouldn't take the firmware any other way. Thanks for the help!

You can change the frequency with M950 Q I believe.

What kind of bed heater is it?

I can't see anything obvious in your gcode file.

Ideamaker is fine to try. There's also PrusaSlicer that's pretty easy to get up and going.

I'd also try taking another pass at the calibration. Comment out the M307 commands in your config and start fresh with a PID tuning and then extruder.

https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40

@Phantom329 said in Bad printing quality for unknown reason:

Seems like its not a temperature issue

did you just print the tower? it looks the same for all heights.
you need to script the change of temperature

@Phaedrux I tried changing the Hz from 1 to 1000 but no difference at all. I took a better video and also noted that the bed actually vibrates. It starts at around 55C and sometimes momentarily stops when above 60C (set at 60C) but immediately stops when I turn off the bed heat.
https://drive.google.com/file/d/1k6DX-6bAaiALDYou7UZGFRZKjEFxABVc/view?usp=sharing