HI after buy the duet wifi to mod my ender3 pro i want to connect ther stock lcd to the duet wifi i know that the duets lcd connetor met to connect 20x4 lcd but there is no software support so the pin is repurpose for 11 12 steper for the duex board mean while adding ST7920 to the borad there is a software support but disable in duet wifi and i have to compile my won firmware but i dont know how and i have an idea of use arduino to connect to lcd and port panel due firmware any ideas

@OwenD what reprap firmware version is required to run this? because last time i updated my firmware was like 2 years ago

hi just wondering is there a way to run G29 only if there is no loaded mesh bed compensation in that boot

thanks

@dc42 said in Duet 3 Mini 5+ : Initial announcement:

have almost 300 pre-production boards early in December, so there should be enough for those who want to try them. We are hopeful that these boards will pass the relevant CE approval tests, but we can't guarantee this because so far we have only run some of these tests (the ones most likely to fail) and on a previous PCB revision. That's why we are calling them

nice where can i sing up for preorder

@dc42 any update on duet Maestro with tmc 2209

i just wonder if you can add Ethernet module to the duet wifi or remove the wifi moudle and replace it with 3 party spi ethernet moudle

i want to connect by panel due port and have a direct connection via a wire in serial what should i do

@Phaedrux said in diy panel due:

y_step_guide

in a browser rigth

how to conect duet 2 wifi to raspberry and run duet web interface

what sensor are you useing

@IGEN said in Duet Maestro Not Recognized:

teps and updated the firmware from Pronterface. I now cannot get the board to connect to Pronterface and device manager shows an "Unknown USB Device (Device Descriptor Request Failed)" whenever I try to connect it.
Any help would be greatly appreciated

have you install the usb comport driver