Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Ah you got me wrong : D
The other two colors are loaded until the nozzle, so the Bowden tube is not open. I did this mistake once and my ptfe clogged. This will not happen again : D
At that time I started the post, i did not have any adjusting possibilities for the bed
Now I installed a 3Point system for Pre-Adjusting the printbed
Actually I'm fighting with the first print, somehow it shuts down the heaters when I start a print, but that's another Story 🙂
The problem in this thread is [Solved]
Ask your supplier to replace the Duet under warranty.
Awesome!
